Runehack123
2013-02-10 11:25:09
Just wanted to see if MMtoMS is broken because it wasn't working too well for me..
There is a lot of Y offset not so much X. (my object always ends up slightly below the mouse).
Well I was moving my mouse towards objects using MMtoMS and then looked at the actual co-ordinates of the objects.
I then calculated minimum size of the TBox needed to be created around that MMtoMS red dot on the main screen so the object actually fits inside and I can then check for colours.
These are only a few values, but it was worth getting these in the end since I was just guessing before that and I'm hoping now that it will be more accurate.
[ATTACH=CONFIG]19072[/ATTACH]
Found an error in my spreadsheet…Minor error ..Should look different from what you see :p
Replace…(All boy1 boy2 values are different.)
BOY1 MIN is now -46.. BOY2 MAX is now 28!!
This just shows how big the offset really is.
There is a lot of Y offset not so much X. (my object always ends up slightly below the mouse).
Well I was moving my mouse towards objects using MMtoMS and then looked at the actual co-ordinates of the objects.
I then calculated minimum size of the TBox needed to be created around that MMtoMS red dot on the main screen so the object actually fits inside and I can then check for colours.
These are only a few values, but it was worth getting these in the end since I was just guessing before that and I'm hoping now that it will be more accurate.
[ATTACH=CONFIG]19072[/ATTACH]
Found an error in my spreadsheet…Minor error ..Should look different from what you see :p
Replace…(All boy1 boy2 values are different.)
BOY1 MIN is now -46.. BOY2 MAX is now 28!!
This just shows how big the offset really is.