SRL Archive - Help

Whenever I use RadialWalk or such a function like that, it just lags the SMART client and never actually clicks when I fill out the correct variables for it. It all compiles but never does anything. Should I use SPS walking instead?

RadialWalk does work. Can you post the function you're using? It might be using your radialwalk function in an endless loop when not finding it causing a lot of lag. Usually, adding a small waiting time as well as a failsafe helps a ton.

do these work with private servers if i use an older map? so far it does nothing

From: johnlukey
do these work with private servers if i use an older map? so far it does nothing

Make your own thread.

and yes. It does. but once again, go back to your own thread

Alright. I was using an endless repeat, with no waits. I'll see if it works.

Try using RadialWalkTolerance with dynamic tolerance:

  Tol := 0;
  while True do begin
    if not RadialWalkTolerance({Fill these in}, Tol) then begin
      IncEx(Tol, 10);
      if Tol > 100 then begin
        WriteLn('[FAILURE]: Tolerance is over 100');
        Exit;
      end else Continue;
    end else begin
      WriteLn('[SUCCESS]: Completed Radialwalk');
      Break;
    end;
  end;